Instruction manual

Slave.) For example, to access the computer plugged into port C of a Slave KVM Switch
that is plugged into Port 6 of the Master switch, type:
left Ctrl + left Ctrl + 6 + C
Auto Scan
Auto Scan automatically scans through powered computers at a fixed interval:
left Ctrl + left Ctrl + F1.
When Auto Scan detects any keyboard or mouse activity, it suspends the scanning until
activity stops; it then resumes with the next computer in sequence. The length of the Auto
Scan interval (Scan Rate) is adjustable (see Scan Rate on the following page). To abort
the Auto Scan mode, press the left Ctrl key twice.
Manual Scan
Manual Scan enables you to manually switch back and forth between powered
computers: left Ctrl + left Ctrl + F2
Press the up or down arrow to select the previous or next computer in sequence. Press
any other key to abort the Manual Scan.
NOTE: The Scan Type setting will determine whether computers must be eye-marked to
be included in the scan. See page 25 for details.
Scan Rate
Scan Rate sets the duration between switching to the next computer in Auto Scan mode:
left Ctrl + left Ctrl + F3
The unit switches between scan intervals of 3, 8, 15 and 30 seconds.
Keyboard Typematic Rate
You can adjust the keyboard typematic rate (given in characters/sec). This setting over-
rides the keyboard typematic rate of your BIOS and any operating system.
left Ctrl + left Ctrl + F4
The unit switches between rates of 10, 15, 20 and 30 characters/sec.
Audio Stick
A multimedia module can be LINKed to the back of the master KVM for selecting
microphone and stereo speaker signals. There are two options for Audio Stick: On and
Off. When set to On, audio selection follows computer selection. When set to Off, audio
selection stops following computer selection. It is useful if you want to listen to a
particular computer's audio signal while operating other computers.
left Ctrl + left Ctrl + F5
(Note: This is an optional feature requiring a separate device to be connected to the
Instruction Manual
29