Instruction manual

Configuring SVxx41HDIE
SVxx41HDIE offers four distinct methods for configuring the unit for your network. Which
method will work best will depend on your level of experience and your specific network
configuration.
Please note: Connecting the remote computers prior to following the steps outlined
below can result in system instability. Please refrain from connecting the remote
computers, until the local peripherals have been connected.
Web Configuration Using the On-Screen Display
Upon boot-up, including following a reset, SVxx41HDIE will display a window on the local
video output (front VGA connector), that will appear as follows:
The initial screen will display the IP address assigned by your existing DHCP server (if
present on your network). If no DHCP server is detected, a factory assigned IP address
will be displayed in its place (10.0.0.15 by default). Please make note of the assigned IP
address, as you will need to enter it into your web browser to access the Web Interface.
If static IP addresses are assigned, you will likely need to change the Net Mask, IP
Address and other details, prior to connecting via your Web browser. If this is the case,
connect a local PS/2 keyboard and press the Enter key. In order to proceed, you will
require an administrative username and password. By default, the username and
password are admin. You will be given the opportunity to change the password
(recommended) to be performed once the configuration is complete.
Alternatively, you may press the Setup button on the front panel, and you will not be
asked to enter the admin password if you just press Enter.
At the main OSD menu (pictured on page 6), you will be given several basic setup
options. To configure SVxx41HDIE to your required network settings, use the Network
Setup Wizard. To select from the menus provided, use the arrow keys on your keyboard.
Instruction Manual
5
Assigned IP Address