Instruction manual

9
Web Conguration Using Static IP
Since some networks rely on static IP addresses (every device has a
pre-configured IP address that does not change), the DHCP access
method described above is not applicable in those situations.
To access the Web configuration for this product, you will need
to configure the workstation you are using to the same subnet
(255.255.255.0) and also assign it a valid IP address (i.e.
192.168.1.100). For details on how to change the IP address of your
computer (if necessary), consult your documentation or System
Administrator for assistance.
NOTE: It is advisable to verify whether another device on your network
is using the same IP address as the IP KVM switch before connecting
it to the network, to avoid a conflict. Should an IP address conflict occur
with another device on the network, power off the conflicting device or
assign it another IP address before continuing the installation.
NOTE: Not all IP addresses are valid for a given subnet. If you are
required to change your subnet (and therefore IP address) to configure
the unit, be sure the IP address you choose is within the allowable
range for the 255.255.255.0 subnet.
Once your computer is configured to the same subnet as the IP KVM
switch, you can use the IP address 192.168.1.123 to access the Web
configuration system.