Instruction manual

10
Terminal Conguration Using a Serial Cable
Configuring the IP KVM switch using a serial cable is the best choice
if you need to preconfigure the unit before attaching it to a network,
(i.e. when sending to a branch office, customer site, etc). In general,
the Web configuration is preferable because of its intuitive interface
and the fact that you do not have to be within close physical proximity
to perform the configuration. However, if you wish to use the serial
cable method to configure the IP KVM switch, you can use any typical
communication software package (UNIX: tip, cu, kermit, minicom;
Windows: HyperTerminal, kermit).
You can use the serial port on the SVxx41HDIE to access the terminal
configuration tool; to do so, you will require a null modem serial cable.
Connect a female end of a serial cable to the serial port used for
serial access on the host computer. Connect the opposite end to the
SVxx41HDIE. Configure the terminal software with “8N1” settings:
Connection speed: 115200 bps
No. of bits: 8
Parity: None
Stop bits: 1
*sample HyperTerminal configuration