Instruction manual

14
The Admin functions allow you to access all of the features you will
need to perform an initial configuration of the IP KVM switch.
Dynamic Host Configuration Protocol (DHCP)
Automatic network configuration using DHCP is: Enabled/Disabled.
This feature applies only to the LAN port on the rear panel, and is
enabled by default. When enabled, the unit will automatically configure
itself with an IP address when a DHCP server is present. When
disabled, the LAN port will use the values assigned to it on the IP
Addresses and Routing table below.
IP Addresses and Routing
This table allows you to assign IP information for the LAN port. If
you are using DHCP, the values for the LAN port will be filled in
automatically and any changes made will not affect the setup.
Domain Name Server (optional)
This section allows you to specify DNS servers and the default DNS
domain suffix in use on the network. If DHCP is enabled, some of these
values may be supplied automatically.
Clicking the Commit button applies any changes made on this page,
but leaves the old settings active until the next time the unit restarts.
Clicking Make changes effective now applies the changes and restarts