User manual

Using Your KVM Switch

There are two ways to access your connected computers: the front panel pushbutton or a

hotkey sequence.

Using the Pushbutton

Pressing the pushbutton on the front of the KVM switch allows you to scroll through

your computers sequentially.

Using the Hotkey Commands

A keyboard hotkey sequence consists of three keystrokes. Each hotkey sequence starts

with two Scroll Lock keystrokes. You must strike the Scroll Lock key twice in two

seconds or less in order for the hotkey sequence to be acknowledged.

Troubleshooting

Keyboard/mouse problems

•You should have connected your keyboard, mouse, and monitor to the KVM switch

before connecting the switch to your computer. If you reversed this process, try

rebooting your PCs.

• Make sure the mouse/keyboard are properly connected to the KVM switch and that

you have installed the proper drivers for your mouse/keyboard.

•Try rebooting your KVM switch by pressing ScrLk + ScrLk + End.

• If your keyboard/mouse came unplugged while in operation, you may need to

reboot your PCs in order to get the switch to recognize the keyboard/mouse again.

Command Hotkey Sequence Description

Select PC ScrLk + ScrLk + 1 (2, 3, 4) Selects the PC plugged into Port 1 (2, 3, 4)

Next lower PC ScrLk + ScrLk + Up Selects the next (lower) PC.

Next higher PC ScrLk + ScrLk + Down Selects the next (higher) PC.

Start Autoscan ScrLk + ScrLk + S Starts autoscan mode. You can quit

autoscan mode by pressing any key.

Autoscan Beep ScrLk + ScrLk + B Toggles on/off the confirmation beep

while in autoscan mode.

Reset KVM ScrLk + ScrLk + End Resets the KVM switch.