User Manual

9
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
4. Insert eight M8 Bolts through eight M8 Washers and into
the holes in the Corner Sections (x2) and Center Sections.
(Figure 3)
5. Tighten the M8 Bolts on the Centre Section Assembly
using the 13 mm Wrench.
Assemble the Rack
1. Place one Left Vertical Rail and Right Vertical Rail on the
ground so that they are parallel to one another.
Note: The rack height numbers should be facing outwards
and up.
2. Insert one Center Section Assembly between the bottom
of the Left Vertical Rail and the Right Vertical Rail. Ensure
the holes in the ends of the Center Section Assembly align
with the holes in the bottom of the Left Vertical Rail and
the Right Vertical Rail.
Note: The Setting Numbers on the Center Section
Assembly should be facing the ground.
3. Lift a Base Bracket so that it is vertical and align the two
holes in the side with the two holes in the Vertical Rail and
Center Section Assembly.
Figure 3