User Manual

14
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
2. Insert four M6 Screws through four M6 Flat Washers and
down through the holes in the Rack
3. Thread four M6 Flange Nuts onto the M6 Screws. (Figure 8)
4. Hold the M6 Screws with the Pliers and tighten the M6
Flange Nuts with the 10 mm Wrench.
Note: The M6 Screws will freely rotate if they are not held to
prevent rotation.
5. Repeat steps 1 to 4 to install the three remaining Casters.
Install the Cable Management Hooks
1. Align the Cable Management Hooks with the Cable
Mounting Screw Holes along the back of the Rack.
2. Insert a Hook Mounting Screw though the Rack and into
the Cable Management Hook. (Figure 9)
Figure 8