User Manual

11
8. Slide a second Center Section Assembly between the other
side of the Base Brackets. (Figure 5)
Note: The Setting Numbers on the Center Section
Assembly should be facing the outside of the Rack.
9. Slide the Left Vertical Rail between the Base Bracket and
the Center Section Assembly.
Note: The rack height numbers on the Left Vertical Rail
should be facing upright.
10. Insert two M8 Bolts through two M8 Washers and into the
holes in the Base Bracket that align with the Vertical Rails
and the Center Section Assembly.
11. Tighten the M8 Bolts using the 13 mm Wrench.
12. Repeat steps 9 to 11 to install the Right Vertical Rail.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Figure 5