User Manual
Instruction manual
11
Attach monitors to the crossbars
Warning! Attaching the monitors is a two-person job. Do not attempt to complete this
task by yourself.
Tipping hazard! The ARMBARQUAD is free-standing and when you attach monitors
to it, you increase the tipping hazard. A second person is required to keep the
ARMBARQUAD upright as you attach the monitors.
ARMBARQUAD is designed to be used with monitors that are the same size and weight.
If you attach monitors that are dierent sizes and weights to the ARMBARQUAD, you
do so at your own risk.
Use the 100x100 VESA mounting hole pattern to attach a monitor
To accommodate dierent monitor sizes, the ARMBARQUAD comes with two sets of
screws that are dierent lengths and diameters.
To select the appropriate screws for the type of monitor that you’re using, complete
the following:
• Determine the depth of the mounting holes on the monitor.
• Determine the diameter of the mounting holes on the monitor.
1. Place two of the washers over the top two mounting holes on the back of the
monitor.
2. Insert two of the M4x12 mm screws or M5x12 mm screws through the washers
and into the back of the monitor. (gure 11)
Caution! At this point in the assembly, do not tighten the screws so that they are ush
against the monitor. To attach the monitor to the VESA monitor mount, you need to
leave a small gap between the screws and the monitor.
Monitor
M4x12 mm screw
or
M5x12 mm screw
Washer
gure 11