User Manual

Instruction manual

Attach a monitor to the crossbar

Warning! Make sure that the weight of the monitor that you attach to the crossbar

does not exceed the weight capacity of this product. If you exceed the weight capacity,

you might experience personal injury or damage to the product.

This product can support up to 17. 6 lb. (8 kg) per monitor.

1. To accommodate dierent monitor designs, the ARMBARTRIO2 comes with two sets

of screws that are dierent lengths and diameters. To select the appropriate screws

for the type of monitors that you’re using, determine the depth and diameter of the

mounting holes on the monitors.

2. Arrange the crossbar so that the holes on the VESA monitor mount line up with the

mounting holes on the back of one of your monitors.

3. Position four of the washers over the holes on the VESA monitor mount.

4. Insert four of the M4x14 mm screws or the M5x14 mm screws through the washers,

the VESA monitor mount, and into the monitor. (gure 3)

5. Use a Phillips type screwdriver to tighten the screws.

Warning! Do not over-tighten the screws. If you encounter resistance while you’re

tightening the screws, stop tightening. Failure to do so could result in damage to the

monitor.

Top of monitor

Crossbar

M4x14 mm screw

M5x14 mm screw

Washer

gure 3