User Manual
Table Of Contents
- Warning Statements
- Product Diagram
- Product Dimensions
- Product Information
- Package Contents
- Product Specifications
- Requirements
- Mounting the Monitor Arm Using the C-Clamp
- Using the Grommet Mount
- Attaching the Monitors (Flush)
- Attaching the Monitors (Recessed)
- Mounting the Monitors
- Adjusting the Monitors
- Tilt Adjustment
- Micro Adjustments
- Routing the Cables
14
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
5. Using the 4 mm Hex Key, tighten the three Pole Assembly
Screws. Being careful not to over-tighten the Pole Assembly
Screws.
6. Remove the backing from the Rubber Pads (x 5).
7. Apply the adhesive side of the Rubber Pads to the under
side of the top of the C-Clamp.
Attaching the C-Clamp to the Pole
8. While supporting the weight of the Monitor Arm, slide the
C-Clamp over the edge of the Mounting Surface.
9. Using your hand, tighten the Knob until the C-Clamp is
pressed tightly against the Mounting Surface.