User Manual
Table Of Contents
- Warning Statements
- Product Diagram
- Product Dimensions
- Product Information
- Package Contents
- Product Specifications
- Requirements
- Mounting the Monitor Arm Using the C-Clamp
- Using the Grommet Mount
- Attaching the Monitors (Flush)
- Attaching the Monitors (Recessed)
- Mounting the Monitors
- Adjusting the Monitors
- Tilt Adjustment
- Micro Adjustments
- Routing the Cables
26
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Note: Do not over-tighten the Screws. If you encounter re-
sistance while you’re tightening the Screws, stop tightening.
Failure to do so could result in damage to the monitor.
7. Repeat steps 1 - 6 to mount the second Monitor.
Attaching the Monitors (Recessed)
Note: It is recommend that two people are used to mount
the Monitors to the Monitor Mounts.
1. Determine the size and length of screw to use to mount the
Monitors to the Monitor Mounts (M4 x 12 mm or M5 x 12
mm, if appropriate).
2. Lay the Monitor face down on a at, level surface.
3. Align the Spacers (x 4) with the Screw Holes on the back of
the Monitor.
4. Align the Mounting Holes on the VESA Mount with the
Spacers on the back of the Monitor, making sure that the
Mounting Flange on the VESA Mount is at the top.
5. Align the Washers (x 4) with the Mounting Holes on the
VESA Mount.
6. Insert the Screws (x 4) through the Washers and Mounting
Holes and into the Screw Holes in the back of the Monitor.