Technical Specs

Instruction manual

Technical specications

The ARMSLIMDUO can support up to 8.0 kg (17.6 lb) of weight per mounting arm. The

desk clamp can support a maximum thickness of 90 mm (3.54 in.).

Assemble the ARMSLIMDUO

Warning! Make sure that all of the hardware is assembled securely and checked for

stability before you load the monitors.

Note: You will need a Phillips screwdriver to assemble the ARMSLIMDUO.

Attach the desk clamps to the mounting arms

1. Line up the four holes in one of the desk clamps (upper bracket) (2) with one set of

four holes on the underside of the mounting arm (1).

2. Insert four of the M6x12 mm screws (10) through the holes in the desk clamp (upper

bracket) and into the mounting arm.

3. Use the M4 Allen key (8) to turn the screws clockwise to tighten them (gure 1).

4. Repeat steps 1 to 3 for the second desk clamp (upper bracket).

5. Line up the two holes in one of the desk clamps (lower bracket) (3) with the two

holes on the end of one of the desk clamps (upper bracket). Make sure that the

hand screw on the desk clamp (lower bracket) is pointing downwards and away

from the mounting arm.

6. Insert two of the M8x12 mm screws (11) through the holes in the desk clamp (lower

bracket) and into the desk clamp (upper bracket).

7. Use the M5 Allen key (9) to turn the screws clockwise to tighten them (gure 2).

gure 1