User Manual

Instruction manual
11
Route the cables
Make sure that the cables that you’re routing are unplugged before you complete the
following steps.
1. Remove the cable covers from the spring mounting arms.
2. Run the cables along one of the spring mounting arms and hold the cables in place
while you snap the cable covers back onto the spring mounting arm. (gure 11)
3. Repeat step 2 for the second set of cables.
4. Use a Phillips screwdriver to remove the cable covers from the extension mounting
arms.
5. Place the cables inside one of the cable covers and use the Phillips screwdriver to
reattach the cable cover to one of the extension mounting arms. (gure 12)
6. Repeat steps 4 and 5 for the second set of cables.
Warning! Make sure that you leave enough slack at the arm joints so that the arms can
be fully extended.
gure 11
Cable cover
Spring mounting
arm
Extension mounting arm
Cable cover
Phillips screwdriver
gure 12