User Manual

Instruction manual
5
Technical specications
The ARMSLIMDUO can support up to 8.0 kg (17.6 lb) of weight per mounting arm. The
desk clamp can support a maximum thickness of 90 mm (3.54 in.).
Assemble the ARMSLIMDUO
Warning! Make sure that all of the hardware is assembled securely and checked for
stability before you load the monitors.
Note: You will need a Phillips screwdriver to assemble the ARMSLIMDUO.
Attach the desk clamps to the mounting arms
1. Line up the four holes in one of the desk clamps (upper bracket) (2) with one set of
four holes on the underside of the mounting arm (1).
2. Insert four of the M6x12 mm screws (10) through the holes in the desk clamp (upper
bracket) and into the mounting arm.
3. Use the M4 hex key (8) to turn the screws clockwise to tighten them. (gure 1)
4. Repeat steps 1 to 3 for the second desk clamp (upper bracket).
1
2
10
8
gure 1
5. Remove the backing from the two rubber pads (12), and ax them over the
M6x12 mm screws in the desk clamp (upper bracket). (gure 2)