Wall-Mount Monitor Arm - Dual Swivel ARMWALLDS *actual product may vary from photos FR: Guide de l’utilisateur - fr.startech.com DE: Bedienungsanleitung - de.startech.com ES: Guía del usuario - es.startech.com NL: Gebruiksaanwijzing - nl.startech.com PT: Guia do usuário - pt.startech.com IT: Guida per l’uso - it.startech.com For the latest information, technical specifications, and support for this product, please visit www.StarTech.com/ARMWALLDS.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols PHILLIPS® is a registered trademark of Phillips Screw Company in the United States or other countries. This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech.
Warning statements Mensagens de aviso Make sure to assemble this product according to the instructions. Failure to do so might result in personal injury or property damage. Certifique-se de que monta este produto de acordo com as instruções. O incumprimento pode resultar em ferimentos pessoais ou danos de propriedade. Make sure that the weight of the TV doesn’t exceed the weight capacity of this product. If you exceed the weight capacity, you might experience personal injury or damage to the equipment.
Table of Contents Warnings....................................................................................................................................................... i Introduction.............................................................................................1 Product dimensions.................................................................................................................................. 1 Technical specifications.................................................
Introduction Product dimensions 188 mm min 55 mm to max 38 2 mm 70° 90° mm 75 m 0m 10 90° 90° Instruction manual 1 100 mm 75 mm 154 mm 128 mm
Technical specifications Type of measurement Measurement VESA mounting hole pattern 75x75 100x100 Rated load Up to 15 kg (33 lb.) kg Tilt +450 to -450 Screen size Between 330 mm and 686 mm (13 in. and 27 in.
Package contents 1 2 Display arm Mounting plate Qty: One Qty: One 4 3 2.
7 M4x14 mm screws M5x14 mm screws Qty: Four Qty: Four 9 10 Mounting screws Screw anchors Qty: Two Qty: Two 11 Instruction manual Qty: One Instruction manual 4
Requirements • A monitor or display that is compatible with one of the VESA mounting hole patterns that ARMWALLDS supports • A Phillips screwdriver Requirements are subject to change. For the latest requirements, please visit www.StarTech.com/ARMWALLDS. Installation Attach the mounting plate to a wall Warning! Wall structures vary, and it is important that you make sure that the type of structure and mounting hardware that you are using will properly support the mounted equipment.
Attach a monitor to the display arm Warning! Attaching the monitor is a two-person job. Do not attempt to complete this task by yourself. To accommodate different monitor sizes, the ARMWALLDS comes with two sets of screws that are different lengths and diameters. To select the appropriate screws for the type of monitor that you’re using, complete the following: • Determine the depth of the mounting holes on the monitor. • Determine the diameter of the mounting holes on the monitor. 1.
4. Carefully lift up the display arm with the monitor attached and slide the display arm into the mounting plate. (figure 3) figure 3 Display arm Mounting plate 5. Insert the set screw into the mounting plate and display arm. 6. Use the 2.5 mm hex key to tighten the set screw. (figure 4) figure 4 Set screw 2.
7. Run the monitor cable through the cable-management hook on the bottom of the mounting plate. (figure 5) figure 5 Cable-management hook Adjust the angle of the monitor To position the monitor, do either of the following: • Use the 5 mm hex key to loosen the screw in the monitor mount. Move the monitor and then tighten the screw again. (figure 6) • Use the 4 mm hex key to adjust the swivel joints in the display arm.
Technical support StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of online tools, documentation, and downloads. For the latest drivers/software, please visit www.startech.com/downloads Warranty information This product is backed by a two-year warranty. StarTech.
Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise. StarTech.com is your one-stop source for every connectivity part you need. From the latest technology to legacy products — and all the parts that bridge the old and new — we can help you find the parts that connect your solutions. We make it easy to locate the parts, and we quickly deliver them wherever they need to go. Just talk to one of our tech advisors or visit our website.
