User Manual

16
To view manuals, videos, drivers, downloads, and more visit www.startech.com/support
Assembling the Cable Management Module
The Cable Management Module is used to organize up to 2 cables in the
Modular Table Box.
Assembly Requirements:
Modular Table Box (SKU: BEZ4MOD or BOX4MODULE) x 1
Cable Management Module x 1
Cable Management Bracket x 1
Small Cable Bushing x 1
Large Cable Bushing x 1
Cable Management Plate x 2
Plate Screws (#6-32 x 3/8) x 4
Bracket Screws (#6-32 x 3/8) x 4
Tools
Phillips Head Screwdriver x 1
1. Align one of the Cable Management Plates with the Plate Screw Holes
and Bushing Holes on the top of the Cable Management Bracket. Insert
2 of the Plate Screws through the Cable Management Plate and into the
Cable Management Bracket.
2. Using the Phillips Head Screwdriver tighten the 2 Plate Screws, securing
the Cable Management Plate in place. Be careful not to over tighten the
Plate Screws.
3. Insert one cable (max 7.9 mm diameter) through the slit in the Small Cable
Bushing. Using just enough force to get the cable through the slit without
damaging the bushing.
4. Insert one cable (max 14.5 mm diameter) through the slit in the Large Cable
Bushing. Using just enough force to get the cable through the slit without
damaging the bushing.
5. Feed the cables through the bottom of the Cable Management Bracket.