Installation Instructions
Revision: 04/17/2013
For the most up-to-date information, please visit: www.startech.com
C6KEY110SWH
UTP 180 Keystone Jack
1. Strip o 1-inch (2.5cm) of jacket from one end of the
Cat6 cable.
2. Place the wires into the keystone jack, setting the
wire pairs into the IDC according to the displayed
wiring conguration (A or B) and punch down the
connections.
3. Cut excess wire after punching down the wire pairs.
4. Place the cover over the wires.
NOTE:
1. Never install telephone wiring during a lightning storm.
2. Never install telephone wiring in a wet location unless the wiring is specically designed for wet locations.
3. Never touch un-insulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.