Manual

IInnssttaallllaattiioonn

Installing the Hard Drive in the Caddy

1. Remove the caddy from the bay by lifting the handle and sliding the caddy out of the

bay.

2. Remove the top panel from the caddy by pressing the cover release button and sliding

the lid towards the back of the caddy.

3. Connect the SATA ribbon to the hard drive, making sure that the red wire is on Pin 1.

NOTE: If you are unsure of the location of Pin 1, contact your hard drive manufacturer.

4. Attach the power connector to the hard drive.

5. Gently place the hard drive in the caddy, making sure that the screw-holes on the

bottom of the hard drive line up with the holes in the caddy.

6. Firmly hold the hard drive to the shock absorber plate and use the four 6-32 x

1/4”(coarse thread) screws to mount your hard drive to the drawer from underneath.

7. Replace the top panel of the caddy.

Instruction Manual

*Note: Mount screws to underside of drawer