User Manual

Instruction manual
12
(continued from previous page)
The following hardware combinations work with an inset mounting surface:
M8x50 mm
or or
Attach the vertical brackets to the TV
Warning! Do not over-tighten the screws. If you encounter resistance while you’re
tightening the screws, stop tightening. Failure to do so could result in damage to the
TV.
1. Use a screwdriver to remove the screw from the mounting hardware on each of the
vertical brackets (3). (gure 7)
Put the screws to the side; you will need to use them when you hang the TV.
2. Flip down the smaller piece of the mounting hardware.
gure 7
Vertical bracket
Mounting hardware
Screw