User Manual

Instruction manual
13
Mount a TV with a ush mounting surface
To accommodate dierent TV designs, the FPCEILPTBSP comes with ve sets of screws
of dierent lengths and diameters, and two sizes of spacers.
1. To select the combination of mounting hardware that you need to use to attach the
vertical brackets to the TV, complete the following:
• Determine the depth of the mounting holes on the TV.
• Determine the diameter of the mounting holes on the TV.
Note: If you’re using a TV with a ush mounting surface, you don’t need to use any of
the provided spacers.
2. Line up the vertical brackets with the mounting holes on the back of the TV.
3. Place the rectangular washers over the mounting holes in the vertical brackets.
4. Insert the M5x14 mm screws or the M6x14 mm screws through the washers,
vertical brackets, and into the back of the monitor. (gure 8)
5. Use a Phillips screwdriver to tighten the screws.
Warning! Do not over-tighten the screws. If you encounter resistance while you’re
tightening the screws, stop tightening. Failure to do so could result in damage to the
monitor.
M5x14 mm screw
M6x14 mm screw
Rectangular washer
Vertical bracket
gure 8