Manualshelf

Technical Specs

ManualsBrandsStartech ManualsHardwareStarTech.com 10G Network Card 2x 10G Open SFP+ Multimode LC Fiber Connector - Intel 82599 Chip - Gigabit Ethernet Card - network adapter - PCIe 2.0 x8
123456789
Instruction Manual
4
Connect to a network
1. Turn o your computer and any peripherals connected to your computer (for
example, printers, external hard drives, and so on).
2. Unplug the power cable from the back of your computer.
3. If you haven’t done so already, insert one or two compatible 10GBase SFP+
tranceiver module(s) of your choice into the SFP+ slot(s) on the card.
4. Prepare a ber network cable with corresponding connectors for the two end
devices. One end will connect to the 10GBase ber card, while the other end will
connect to a 10GBase ber port on your network switch or device.
5. Connect the ber network cable to the proper connector on your SFP+ transceiver
module on the 10GBase ber card.
6. Connect the other end of the ber network cable to your 10GBase-LR/SR/LRM
switch.
7. When the ber network cable is connected properly, connect the power cable again
and turn on your computer.
8. Check the LED on the 10GBase card to make sure a connection was established.
Connection: Solid, green LED
Activity: Blinking, green LED