Owners manual

Instruction Manual

3. From the rear of the cabinet, slide the KVM console onto the mounting rails.

4. Install one screw on each side of the console (as depicted below).

Connecting computers to the module

Attach each of your managed computers to your StarView KVM console’s PC ports

using ultra-thin KVM cables. The Module is capable of using either 2-in-1 USB or 3-in-1

PS/2 cables. Use the cables to connect one of the PC ports on the back of the switch to

the computer's keyboard, mouse, and video ports. Note: These instructions are for a

single KVM switch only.

Following this, plug the 12V DC power adapter into the power port on the KVM module,

and turn on the computers that will be controlled by the console.

Note: After the initial power up, you can hot-plug additional computers or slave KVM

switches without having to power down your KVM