Owners manual

Instruction Manual
13
MMoodduullee ooppeerraattiioonn
Push Button Selection
A computer may be selected by pressing the push buttons above the keyboard on the
Console, by issuing hot-key commands or by activating the OSD window. The indicator
LEDs change to reflect the computer port selected (red). The indicator flashes red when
it is in either Auto Scan or Manual Scan mode.
The K/M Reset function (on the module) reconfigures your system without powering
down your computers or your KVM switch. To reset the switch, press and hold the front-
panel 1 and 2 buttons simultaneously.
The Auto-Scan function automatically scrolls through your connected computers. Press
and hold the front-panel 7 and 8 buttons simultaneously to enter Auto Scan mode.
By hitting the left <CTRL> key twice within two seconds, you may see the Hotkey Menu
(if it is enabled as an OSD option). Or, by hitting the left <CTRL> key three times within
two seconds, you will see a KVM MENU screen (below) showing a list of the computers
with corresponding channel addresses, names and status.
The port number of the currently selected computer is displayed in red, same as the front
indicator, at the right corner of the OSD menu.
The color of a device name is green if it has power and is ready for operation, or the
color is white if it has no power. The OSD menu updates the color when it is activated.
Use the <> and <> arrow keys to highlight a computer and the <ENTER> key to