Owners manual

Instruction Manual
17
Left Ctrl + left Ctrl + 7
Selects a computer connected to port 7 of the Master.
Left Ctrl + left Ctrl + 6 + C
Selects a computer connected to port C of a Slave connected to port 6 of the
Master.
To start Auto Scan, automatically scan power-on computers one by one at a fixed
interval:
Left Ctrl + left Ctrl + F 1
When Auto Scan detects any keyboard or mouse activity, it suspends the scanning
till activity stops; it then resumes with the next computer in sequence. The length
of the Auto Scan interval (Scan Rate) is adjustable, see below. To abort the Auto
Scan mode, press the left Ctrl key twice.
Note: Scan Type determines whether an eye-marked computer is to be displayed
during Auto Scan.
•
Manual Scan enables you to manually switch back and forth between power-on
computers.
Left Ctrl + left Ctrl + F2
Press  or  to select the previous or the next computer in sequence. Press
any other key to abort the Manual Scan.
Note: Scan Type determines whether an eye-marked computer is to be displayed
during Auto Scan.
To adjust Scan Rate which sets the duration before switching to the next computer
in Auto Scan:
Left Ctrl + left Ctrl + F3
The 1UCABCONS sends one to four beeps indicating scan interval of 3, 8, 15 and
30 seconds respectively.
•
To adjust keyboard typematic rate (characters/sec), this setting over-rides that of
BIOS and any operating system:
Left Ctrl + left Ctrl + F4
The Console will generate 1 to 4 beeps corresponding to 10, 15, 20 and 30
characters/sec respectively.