Instruction Manual

ManualsBrandsStarTech ManualsFurniture & Rack AccessoriesRail Depth Adapter Kit for Server Racks

Instruction manual

FR: Guide de l’utilisateur - fr.startech.com

DE: Bedienungsanleitung - de.startech.com

ES: Guía del usuario - es.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

IT: Guida per l’uso - it.startech.com

Manual Revision: 04/19/2016

For the latest information, technical specications, and support for

this product, please visit www.StarTech.com/RDA1U.

Package contents

• 2 x depth-adapter brackets

• 4 x 10-32 x 5/8 screws

• 4 x 10-32 cage nuts

• 1 x instruction manual

System requirements

• Server rack

• Phillips head screwdriver

System requirements are subject to change. For the latest

requirements, please visit www.StarTech.com/RDA1U.

RDA1U

Rail Depth Adapter Kit for Server Racks - 1U

*actual product may vary from photos

Introduction

The depth-adapter kit addresses the frustration of having

components that are too long or too short for your current server

rack. Instead of having to purchase new components or server racks,

you can use the RDA1U to increase or decrease the mounting depth

of your server rack rails by 4 in. (10 cm).

Product diagram

Equipment-

mounting hole

Rack-mounting

hole

Technical specications

The depth-adapter brackets use one unit of your server rack and are

designed to support up to 10 lb. of weight.

Decrease the depth of your server rack

Note: When you install the brackets, make sure that the rack-

mounting holes are on the outside of the server rack.

1. Position one of the depth-adapter brackets so that the end with

the equipment-mounting holes extends into the server rack

(diagram 1).

2. Insert a 10-32 x 5/8 screw through each of the rack-mounting

holes and into the server rack.

3. Repeat steps 1 and 2 for the second bracket.

diagram 1

Summary of content (2 pages)

PAGE 1
Instruction manual Rail Depth Adapter Kit for Server Racks - 1U RDA1U Decrease the depth of your server rack Note: When you install the brackets, make sure that the rackmounting holes are on the outside of the server rack. 1. Position one of the depth-adapter brackets so that the end with the equipment-mounting holes extends into the server rack (diagram 1). 2. Insert a 10-32 x 5/8 screw through each of the rack-mounting holes and into the server rack. 3. Repeat steps 1 and 2 for the second bracket.
PAGE 2
Increase the depth of your server rack Note: When you install the brackets, make sure that the rackmounting holes are on the outside of the server rack. 1. Position one of the depth-adapter brackets so that the end with the equipment-mounting holes extends outside of the server rack (diagram 2). 2. Insert a 10-32 x 5/8 screw through each of the rack-mounting holes and into the server rack. 3. Repeat steps 1 and 2 for the second bracket.