User Manual
ManualsBrandsStartech ManualsExternal Storage EnclosuresStarTech.com USB-C 10Gbps to M.2 NVMe or M.2 SATA SSD Enclosure, External M.2 PCIe/SATA NGFF SSD Enclosure, Portable Aluminum Case, USB Type-C & USB-A Host Cables, For 2230/2242/2260/2280 Works w/ Thunderbolt 3 - storage enclosure - M.2 Card - USB 3.2 (Ge
Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: April 20, 2021 3:03 PM
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Product Diagram (SM2E1BMU31C)
Exterior - Enclosure
Component Function
1 Drive-Tray Screws x 2
• Used to secure the Drive Tray in the
Enclosure.
2 Power & Activity LED
• Indicates that the Enclosure is receiving
power.
• Blinks during read/write activity.
3 USB-C Port
• Used to connect the Enclosure to the Host
Computer.
Interior - Drive Tray
Component Function
4 Drive Connector • Used to connect the Drive to the Enclosure.
5
Adjustable Drive
Length Holes
• Used to accommodate dierent drive lengths.
6
Drive-Mount Screw/
Stando/Nut
• Used to secure the Drive to the Enclosure.
M.2 SATA/NVMe SSD Enclosure - USB 3.2 (10Gbps) w/ USB-C and USB-A Cables
Package Contents
• M.2 SSD Enclosure x 1
• USB-C to USB-C Cable x 1
• USB-A to USB-C Cable x 1
• Drive Installation Screw Kit x 1
• Micro Screwdriver x 1
• Quick-Start Guide
Product Information
For the latest requirements, please visit
www.startech.com/SM2E1BMU31C
Product Requirements
• M2 SATA/NVMe SSD x 1
• 30 mm, 42 mm, or 60 mm Drive Length
• Needle-nose Pliers x 2
Installation
Installing a Drive
Warning! Handle drives with care.
1. Remove the Drive Tray Screws (x 2) from the Enclosure, using a Phillips Head
Screwdriver, and remove the Cover Plate.
2. Carefully pull the Drive Tray out of the Enclosure.
3. Remove the Drive-Mount Screw, using a Phillips Head Screwdriver.
4. Place the Drive next to the Drive Tray and align the screw holes in the Drive with
the Adjustable Drive Length Holes on the Drive Tray to determine the desired
Adjustable Drive Length Hole setting.
Note: If the drive mounting hardware is already installed in the correct position,
proceed to step 8.
5. Remove the Drive Stando and Nut, using two sets of Needle-nose Pliers.
6. Insert the Drive Stando and Nut into the Adjustable Drive Length Hole (60, 42,
or 30) according to the length of the Drive.
7. Tighten the Stando and Nut, using two sets of Needle-nose Pliers.
1
2
3
4
6
5