User Manual

Quick-Start Guide
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Manual Revision: July 18, 2019 12:19 PM
Product Diagram (SSPMSUDWM)
Component Function
1
Docking Station
Mount
• Used to mount a StarTech.com Docking
Station or Hub to a desk or wall.
2 Mounting Holes
• Used to mount the Docking Station Mount to
a desk or wall.
3
Docking Station
Mounting Holes
• Used to mount a StarTech.com Docking
Station or Hub to the Docking Station
Mount.
Requirements
For the latest requirements, please visit www.startech.com/SSPMSUDWM
• Robertson Head Screwdriver x 1
Package Contents
• Docking Station Mount x 1
• M3 x 5 mm Screws x 4
• #5-20 x 5/8” Wood Screws x 4
• Quick-Start Guide x 1
Mount for StarTech.com Docking Stations and Hubs
Attaching a StarTech.com Docking Station or Hub
1. Align the Mounting Holes on the Adapter with the Mounting Holes on the
StarTech.com Docking Station or Hub. The recessed hole pattern should be facing
outward so the M3 x 5 mm (Countersunk) Screws will t properly.
2. Insert the four M3 x 5 mm Screws through the Mounting Holes on the Adapter
and into the Mounting Holes on the Startech.com Docking Station or Hub.
3. Using a Phillips Head Screwdriver (sold separately) tighten the M3 x 5 mm Screws,
being careful not to over-tighten the M3 x 5 mm Screws.
Mounting the Docking Station Mount on a Desk
Note: Make sure that the thickness of the Desk is greater than 12.5 mm (.5”) to ensure
that the screws do not penetrate the opposite side of the desk.
1. Align the Docking Station Mount on the desk.
2. Insert the #5-20 x 5/8” Wood Screws in the Mounting Holes on the Docking
Station Mount.
3. Using a Robertson Head Screwdriver (sold separately), tighten the #5-20 x 5/8”
Wood Screws.
Mounting the Docking Station Mount on a Wall
Notes: It is recommended to use wall studs when mounting the Docking Station
Mount onto a Wall.
You may need to drill pilot holes when mounting the Docking Station Mount into a
wall stud.
1. Align the Docking Station Mount on the Wall.
2. Insert the #5-20 x 5/8” Wood Screws in the Mounting Holes on the Docking
Station Mount.
3. Using a Robertson Head Screwdriver, tighten the #5-20 x 5/8” Wood Screws.
2
1
3