Manual

3
Installation
Hardware Installation
Connect the VGA monitor/display to the VGA output connector on 1.
the Video Switch. Power on the monitor/display.
Connect a male/male VGA cable from the VGA video source (i.e. 2.
computer video card) to the Port 1 VGA input on the Video Switch.
This is the Primary input, so will be automatically selected, when a
video signal is present.
Using a male/male VGA cable, connect the secondary VGA video 3.
source to the Port 2 VGA input on the Video Switch. This is the
Secondary input, so will be automatically selected, if a video signal
is not present on the Primary input.
Connect the external power adapter to the Video Switch.4.
Power on the VGA video sources one at a time. The Online LED 5.
on the front panel will light up when a video signal is found for each
input.
Driver Installation
No driver or software installation is required on any computer system.
How to Use
The Primary input on the Video Switch take precedence when a
video signal is present. When a video signal is no longer present on
the Primary input, the Video Switch will automatically switch to the
Secondary input. Once a video signal is restored to the Primary input,
the Video Switch will automatically switch to the Primary input.
The selected input on the Video Switch can be manually chosen via
the front panel buttons. Pressing the “Select” button for the desired
input will immediately select it. This selection will remain in affect, until
a video signal disconnect/reconnect is sensed on the Primary input.