Owners manual

4POSTRACK36

DuraRak 36U Adjustable 4 Post Open Frame Rack

Packaging Contents

2 x Front/Rear Frame •

2 x Floor Plates•

6 x Adjustable Horizontal Arm•

2 x Floor Mounting Brackets•

1 x M8 Hex (Allen) key•

8 x M8x25 Hex Socket Screws•

42 x M5x15 Truss Head Screws•

16 x Bushing Caps•

50 x Cabinet Screws•

50 x Cage Nuts•

Installation

Make sure that the front and rear frames are right side up. 1.

The bottom of the frame has holes for the ﬂoor mounting

brackets and casters. Make sure that the pictured end is at

the bottom.

Attach the ﬂoor mounting brackets (the L-shaped brackets) to the bottom of the frames. Using the included hex key, 2.

install the hex socket screws. Install 4 screws per bracket.

Attach the arms to the frames. Separate your arms into pairs (consisting of one wide and one narrow arm per pair).You 3.

will have six pairs of arms, three for each side of the rack. The narrow arms that connect the bottom of the frames can

be identiﬁed by the pre-mounted cage nuts on the inside of the arms.

NOTE: When installing the arms, it might be easiest to start with the top arms for stability reasons.

Hex Socket Screws

Pre-installed cage

nuts

Tools Required

1 x Phillips (crosshead) Screwdriver•

Optional Caster

mounting point, on

bottom of rack frame

WARNING! Please ensure that the rack is full assembled with

all included parts and fasteners before attempting to mount any

rack equipment. Failure to install and fully tighten any hardware

could severely compromise the structural integrity of the rack. If

any hardware is missing, please contact StarTech.com customer

service immediately.

PAGE 1
DuraRak 36U Adjustable 4 Post Open Frame Rack 4POSTRACK36 Packaging Contents Tools Required • 2 x Front/Rear Frame • 2 x Floor Plates • 6 x Adjustable Horizontal Arm • 2 x Floor Mounting Brackets • 1 x M8 Hex (Allen) key • 8 x M8x25 Hex Socket Screws • 42 x M5x15 Truss Head Screws • 16 x Bushing Caps • 50 x Cabinet Screws • 50 x Cage Nuts • 1 x Phillips (crosshead) Screwdriver WARNING! Please ensure that the rack is full assembled with all included parts and fasteners before attempting to mo
PAGE 2
For the top and middle arms, snap the cage nuts into the back (inside) of the narrow arms. It is recommended that you install several cage nuts on each arm. The cage nuts are easier to install when the rack is not fully assembled.You should install more cage nuts than may be necessary in case you change the depth of the rack in the future. Inside of a narrow arm with cage nuts installed Determine the desired depth of your rack.
PAGE 3
Specifications Description DuraRak 36U Adjustable 4 Post Open Frame Equipment Rack Colour Black Materials SPCC (2.0mm) Weight Capacity 450 kg Dimensions (W x H) 571.0 mm x 1713.5 mm Minimum/Maximum Mounting Depth 469.9 mm / 895.