User Manual
Table Of Contents
- Warnhinweise
- Introduction
- Asssembly
- Assemble the base
- Adjust the height of the casters
- Attach the column to the base
- Assemble the TV mount
- Attach the support plate to the column
- Move the support plate to the lowest position
- Attach the adapter brackets to a flush mounting surface
- Attach the adapter brackets to a recessed mounting surface
- Attach the TV to the column
- Counterbalance the weight of the TV
- Attach the plastic cover
- Attach the cable clips
- Install the multimedia shelf
- Attach the camera shelf
- Attach the wrench
- Adjusting the STNDMTV70
- Technical support
- Warranty information
Instruction manual
16
Assemble the TV mount
1. Slide the crossbars through the top and bottom openings in the support plate.
(gure 7)
gure 7
2. Position the crossbars so that they are centered on the support plate and the holes
on the crossbars are aligned with the holes in the support plate.
3. Insert four of the M6x14 mm screws through the crossbars and into the support
plate. (gure 8)
4. Use a Phillips type screwdriver to tighten the M6x14 mm screws.
gure 8
Crossbar
Support plate
Crossbar
Support plate
M6x14 mm screw
Screwdriver