User Manual

Instruction manual
21
Attach the adapter brackets to a ush mounting surface
To accommodate dierent TV designs, the STNDMTV70 comes with ve sets of screws
of dierent lengths and diameters, TV washers with two hole sizes, and two sizes of
spacers.
Warning! Make sure that the weight of the TV doesn’t exceed the weight capacity
of this product. If you exceed the weight capacity, you might experience personal
injury or damage to the product. This product can support the following weight: 40
kg (88 lb.) when the lift mechanism is locked or 8 to 25 kg (18 to 55 lb.) when the lift
mechanism is in use.
1. To select the combination of mounting hardware that you need to use to attach the
adapter brackets to the TV, complete the following:
• Determine the depth of the mounting holes on the TV.
• Determine the diameter of the mounting holes on the TV.
Note: If you’re using a TV with a ush mounting surface, you don’t need to use any of
the provided spacers.
2. Position the adapter brackets so that the hooks on the adapter brackets are pointed
towards the bottom of the TV and are aligned with the mounting holes on the back
of the TV.
3. Depending on the screw size that you’re using, place the TV washers so that either
the small or large holes are positioned over the adapter brackets.
4. Insert the M5x14 mm screws or the M6x14 mm screws through the TV washers,
adapter brackets, and into the back of the TV.
5. Use a Phillips type screwdriver to tighten the screws. (gure 14)
Warning! Do not over-tighten the screws. If you encounter resistance while you’re
tightening the screws, stop tightening. Failure to do so could result in damage to
the TV.