User Manual
Table Of Contents
- Warnhinweise
- Introduction
- Asssembly
- Assemble the base
- Adjust the height of the casters
- Attach the column to the base
- Assemble the TV mount
- Attach the support plate to the column
- Move the support plate to the lowest position
- Attach the adapter brackets to a flush mounting surface
- Attach the adapter brackets to a recessed mounting surface
- Attach the TV to the column
- Counterbalance the weight of the TV
- Attach the plastic cover
- Attach the cable clips
- Install the multimedia shelf
- Attach the camera shelf
- Attach the wrench
- Adjusting the STNDMTV70
- Technical support
- Warranty information
Instruction manual
38
6. Determine the height that you want the camera shelf to be at and line it up with the
mounting slots on the back of the column.
7. Insert the two M6x25 mm screws through the connecting plate and into the
column. (gure 28)
8. Use a Phillips type screwdriver to tighten the screws in place.
Attach the wrench
1. Thread the two hook-and-loop ties through the hole in one of the support brackets
under the multimedia shelf.
2. Hold the wrench against the support bracket and wrap the hook-and-loop ties
around the wrench. (gure 29)
gure 29
Multimedia shelf
Hook-and-loop tie
Wrench