User Manual

Instruction Manual
7
Scan Time
Four options are available for users to set the Scan Time duration, it Includes 3, 8, 15
and 30 seconds.
Note: Scan Time is set to 3 seconds by default.
To adjust Scan Rate, set the scan time of duration before switching to the next
computer:
Left <CTRL> + Left <CTRL> + <F3>
The KVM Switch generates 1 to 4 beeps indicating a scan time duration for 3, 8, 15 or
30 seconds respectively.
Audio Lock
There are two options for Audio Lock: ON and OFF. When ON, audio selection follows
computer selection. When OFF, audio selection stops following computer selection. It
is useful if you want to listen to a particular computer’s audio signal while operating
other computers.
Left <CTRL> + Left <CTRL> + <F5>
The KVM switch beeps once or twice corresponding to ON and OFF respectively.
To change which computer port the audio stays on to the currently selected port, press
the following hotkey:
Left <CTRL> + Left <CTRL> + <A>
USB-Port Rule
There are two settings for USB-Port Rule: ON or OFF.
When set to ‘ON’, the USB Hub port follows computer selection.
When set to ‘OFF’, the USB Hub port stays on the currently selected PC port.
USB 1: press the hotkey below to turn ON/OFF the USB-Port Rule on both USB Hub
ports (2-port only) or USB Hub port 1 (4-port only):
Left <CTRL> + Left <CTRL> + <F7>
USB 2: press the hotkey below to turn ON/OFF the USB-Port Rule on USB Hub port 2
(4-port only):
Left <CTRL> + Left <CTRL> + <F8>
To change the PC port that the USB hub stays on to the currently selected PC port,
press the following hotkey:
Left <CTRL> + Left <CTRL> + <U>
NOTE: Please make sure that installation of the USB device has been accomplished
before switching to the next computer.