Technical Specs

Instruction manual

data capacity of the destination USB ash drive and there is no limit to the

capacity tolerance range, the copying process will fail or be incomplete.

• To set the data capacity of the destination USB ash drive to be the exact same

as the source USB ash drive, highlight 100% Same and press the OK button.

Caution! If the data capacities of the source USB ash drive and destination

USB ash drive aren’t equal, the copying process won’t begin.

• To set the high and low range of the capacity tolerance range between the

source USB ash drive and the destination USB ash drive, highlight Allow

Tolerance and press the OK button. To set the maximum capacity dierence,

highlight No Limit or a numeric value between 0 and 50%, and press the

OK button. To set the minimum capacity dierence, highlight No Limit or a

numeric value between 0 and 50%, and press the OK button.

Change the copying speed

For most types of USB ash drives, you should set the copy speed to Normal.

1. Highlight Setup and press the OK button.

2. Highlight Working Mode and press the OK button.

3. Highlight one of the following and press the OK button:

• Fastest Mode

• Faster Mode

• Normal Mode

• Slower Mode

• Slowest Mode

Tip! If you’re experiencing a high failure rate when you’re copying USB ash drives, try

using a slower copying speed.

Change the time between copy and compare

By default, the duplicator and eraser is set to wait 3 seconds after a copy process

completes before beginning the compare process.

1. Highlight Setup and press the OK button.

2. Highlight Power O Time Between Copy&Compare and press the OK button.

3. Highlight a numeric value between 0 and 15 and press the OK button.