Technical Specs
Instruction manual
8
Complete an asynchronous copy
When you complete an asynchronous copy, the USB ash drives are copied or
compared independently, one at a time. When the green LED indicator next to a USB
ash drive stops blinking, you can remove the USB ash drive even if the other USB
ash drives are not done being copied or compared.
Note: If the data size of the source USB ash drive is larger than the system’s buer
memory, the system will automatically copy in synchronous mode.
Caution! To avoid any copying errors, the source USB ash drive should be larger than
or the same size as the destination USB ash drive.
1. Use the Power switch to turn on the duplicator and eraser.
2. If necessary, change any of the copying settings (for example, copy area, copy
speed, target tolerance, and so on).
3. Insert the source USB ash drive into the Source USB ash drive port.
4. Insert up to 15 destination USB ash drives into the Destination USB ash drive
ports.
5. Highlight Copy and press the OK button.
6. If a conrmation message appears, press the OK button.
7. When the green LED indicator stops blinking, you can remove the destination USB
ash drive and insert another USB ash drive and the process will continue.
8. To check the copy status and progress for each of the USB ash drives, use the UP
and DOWN buttons to move through the USB ash drive ports.
Warning! If the green LED indicator is blinking, do not remove the USB ash drive. If
you do so, you will interrupt the copying process and you could experience lost or
corrupted data as a result.
Interrupt the copying process
1. To stop the copying process while it’s in progress, do one of the following:
• To stop copying data to the slowest USB ash drive port, press and hold the UP
and DOWN buttons for 5 seconds.
• To stop copying data to all of the USB ash drive ports, press and hold the ESC
button for 5 seconds.