Technical Specs
Instruction manual
9
Disable the asynchronous feature
By default, the asynchronous feature is enabled.
1. Highlight Setup and press the OK button.
2. Highlight Asynchronous and press the OK button.
3. Highlight Disable and press the OK button.
Copy to an HDD or SSD
1. Connect a USB to SATA hard drive docking station or a USB to SATA drive enclosure
to the duplicator and eraser.
2. Use the Power switch to turn on the duplicator and eraser.
3. Use the UP and DOWN buttons to navigate the device menu, highlight Setup, and
press the OK button.
4. Highlight Set HDD Mode and press the OK button.
5. Highlight Active and press the OK button.
Compare USB ash drives
After you copy USB ash drives, you can use the compare feature to make sure that the
data was copied successfully.
1. When the copying process is complete, highlight Compare and press the OK button.
2. Use the UP and DOWN buttons to navigate through the USB ash drive ports.
Copy and compare USB ash drives
For increased eciency, you can set the duplicator and eraser to automatically
compare the USB ash drives after the copying process is complete.
1. Highlight Copy+Compare and press the OK button.
2. Use the UP and DOWN buttons to navigate through the USB ash drive ports.