Technical Specs
Instruction manual
10
Formatting a USB ash drive
Warning! When you format a USB ash drive, all of the data on your USB ash drive will
be deleted. If your USB ash drive has data on it that you require, you should create a
backup le or use a dierent USB ash drive.
Auto format a USB ash drive
When you auto format a USB ash drive, the system determines the capacity of the
USB ash drive and formats it accordingly.
Consult the table below for more information about the format that the USB ash drive
will be formatted to.
Original format After auto formatting
FAT16 No change to format
FAT32 No change to format
NTFS, Linux, multi-partition FAT equal
to or greater than 2GB
FAT32
NTFS, Linux, multi-partition FAT less
than 2GB
FAT16
1. Use the Power switch to turn on the duplicator and eraser.
2. To auto format a USB ash drive, insert up to 15 USB ash drives into the Destination
USB ash drive ports.
3. Highlight Utility and press the OK button.
4. Highlight Do Format and press the OK button.
5. Highlight Auto Format and press the OK button.
6. When the conrmation message appears, press the OK button.
7. To check the formatting status, progress, and information about the USB ash
drives, use the UP and DOWN arrows to navigate through the USB ash drive ports.
Format a USB ash drive to FAT16
1. Use the Power switch to turn on the duplicator and eraser.
2. Insert USB ash drives into the USB ash drive ports.