Technical Specs
Instruction manual
14
Update the system rmware
1. Save the rmware update onto a USB ash drive that is formatted to FAT32.
Note: Make sure that the rmware update le is unzipped and not in a folder.
2. Use the Power switch to turn on the duplicator and eraser.
3. Insert the USB ash drive into one of the USB ash drive ports.
4. Highlight Utility and press the OK button.
5. Highlight System Update and press the OK button.
6. When the conrmation message appears, press the OK button.
7. When the rmware update is complete, move the Power switch to the o position.
8. Wait a couple of minutes and then turn on the duplicator and eraser again.
Calculate the checksum number
You can calculate the checksum number of the source USB ash drive. The checksum
area that is calculated is based on the copy area that is set.
1. Use the Power switch to turn on the duplicator and eraser.
2. Insert a USB ash drive into the Source USB ash drive port.
3. Highlight Utility and press the OK button.
4. Highlight Calc. Checksum and press the OK button.
When the calculation is complete, the checksum is displayed on the LCD display.
Measure read and write speeds
You can measure the read and write speeds of the destination USB ash drives.
1. Use the Power switch to turn on the duplicator and eraser.
2. Insert up to 15 USB ash drives into the Destination USB ash drive ports.
3. Highlight Utility and press the OK button.
4. Highlight Measure Speed and press the OK button.
5. To view the read and write speeds for each of the USB ash drives, use the UP and
DOWN buttons to move through the list of the USB ash drive ports.