Technical Specs
Instruction manual
5
1. Highlight Setup and press the OK button.
2. Highlight Copy Area and press the OK button.
3. Do one of the following:
• Highlight System and Files and press the OK button.
• Highlight Whole Media and press the OK button.
Check the ash drive capacity
If a USB ash drive passes the capacity check, the green LED indicator next to the USB
ash drive port illuminates. If a USB ash drive fails the capacity check, the red LED
indicator next to the USB ash drive port illuminates.
1. Use the Power switch to turn on the duplicator and eraser.
2. Insert USB ash drives in any of the USB ash drive ports.
3. Highlight Capacity Check and press the OK button.
4. To view the capacity of the USB ash drives, use the UP and DOWN arrows to
navigate through the list of USB ash drive ports.
Tip! This feature supports asynchronous operation, which means that the system
checks each USB ash drive separately. You can remove a USB ash drive after it has
been checked and insert a dierent USB ash drive and the check will continue.
Set the target tolerance
You can set the capacity tolerance range between the source USB ash drive and
the target USB ash drive, and if the capacity of the USB ash drive is outside of the
tolerance range, the data won’t be copied. For example, if you set the target tolerance
to ±1% and the source USB flash drive is 2GB and the destination USB flash drive is
2.02GB, the data won’t be copied to the destination USB flash drive.
By default, the target tolerance is set to No Limit.
1. Highlight Setup and press the OK button.
2. Highlight Target Tolerance and press the OK button.
3. Do one of the following:
• To disable the capacity tolerance range, highlight No Limit and press the OK
button.
Caution! If the amount of data on the source USB ash drive is larger than the