Operation Manual

Star Trac Studio Series Group Cycle Bikes Owner’s Manual |
10
TESTING EQUIPMENT AFTER ASSEMBLY
Use this checklist to perform the test procedure on all new units.
 Check all nuts and bolts and make sure they are all tightened to the proper torque specification (when
indicated) in the Assembly Instructions, and verify that no parts are missing.
 Test the handlebar and seat post to make sure they move freely, and you are able to lock them in at
different positions.
 Check the seat to make sure it is level and tight, and does not rotate around or tilt. Tighten and adjust as
needed.
 Test the seat slide for movement front to rear, and check it by setting it at different settings.
 Adjust the seat post and handlebar post to your needs. Ride/test the machine for proper operation
according to this owner's manual.
 Pedal the machine at a moderate pace, and test for proper and smooth resistance changes while varying
the amount of turns on the resistance knob.
CAUTION: The flywheel will continue to spin after you pedal, and the crank arms and pedals will rotate
with the flywheel.
Brake tension is adjustable using the red resistance knob in the front of the machine. Pressing down on
the knob will apply the brake if you need to stop quickly.
 When you have completed testing the machine, tip the it forward using the handlebars, roll it on a smooth
surface to the final location where it will be used, and adjust the leveling feet so the machine is stable.