Operating Instructions and Installation Instructions

13
LIFT PULL
INSTALLATION
Note: take special care when unwrapping unit, DO NOT use knifes to cut open packaging damage may occur.
STEPS:
1. Take main body off the pallet and place it on the floor.
2. Attach the platform to the main body.
Use (2) M12 washers, (2) M12 x 30 button head screws, and (2) M12 locking nuts to mount platform to
the
main body, tighten fasteners to (84 NM / 62 ft-lb) torque.
3. Mount the upper arms to the main body
(Note:
this requires (2) people
Use (6) M12 x 30 button head screws, (6) M12 locking nuts, and (6) M12 washers and tighten fasteners to
(10 nm / 7.4 ft-lb)
torque.
. Cables are attached to this assembly, take special care not to pinch,
twist or damage cables).
4. Attach accessories to the
unit.
5. Place urethane boots under
feet.