Operating Instructions and Installation Instructions

14
TOTAL DELTS
INST ALL A TION
NOTE: take special care when unwrapping unit, do not use knifes to cut open packaging damage may occur.
STEPS:
1. Take main body off the pallet and place it on the
floor.
2. Attach the seat pad frame to the main body. (Note: cables are
attached to this assembly, take special
care to not pinch, twist or damage cables
. Make sure cables travel straight).
Use (4) M12 washers and (4) M12 x 30 button head screws to attach seat frame to the main body,
tighten fasteners to (84 NM / 62 ft-lb)
torque.
3. Take the knee pad assembly; remove M6 Phillips head screw and
washer. Slide knee pad assembly into
main body; re-install M6 Phillips screw
and washer.
4. Attach accessories to the
unit.
5. Place urethane boots under
feet.