DUAL ADJUSTABLE PULLEY IP-D9302 INSTALLATION INSTRUCTIONS
Copyright 2010. Star Trac by Core Industries, Inc. All rights reserved, including those to reproduce this book or parts thereof in any form without first obtaining written permission from Star Trac. Every effort has been made to keep this information current; however, periodically, changes are made to the information herein, and these changes will be incorporated into new editions of this publication. All product names and logos are trademarks of their respective owners. Printed in the USA.
INSTALLATION INSTRUCTIONS REQUIRED TOOLS: • 5MM HEX KEY SOCKET • • • • • • • • • • • • • • • • • • •• • • • • • • • • • • • • TORQUE WRENCH • • • • • • • • • • • • • • • • • • •• • • • • • • • • • • • • •• • • • 1 •• ••• GENERAL NOTES: • Unless otherwise noted Loctite 242/243 or equivalent thread locker must be used on all threaded fasteners. (Do not use thread locker when a Nyloc nut is used.) • All Star Trac Strength equipment MUST be secured to the floor using either 10mm or 3/8in.
TOWER ASSEMBLY: 1. Stand one of the DAP towers upright and slide the dip bar assembly onto its mounting sleeve. Now slide the other DAP tower into place using the dip bar assembly as a guide. 2. Locate and install the six (M8,25mm,Button Head Bolts) and six (M8,Flat Washers) as shown. Do not tighten bolts at this time. 3. Install the two rear DAP tower supports using sixteen (M8,25mm,Button Head Bolts) and sixteen (M8,Flat Washers). 4.
2. Slide the guide rods down into the DAP tower frame then tilt the guide gods towards the inside of the DAP as shown. 3. Slide the rubber bumpers up and off of the guide rods and set aside for re installation later. 4. With the top plate still attached to the DAP via the cable, slide top plate up and off of the guide rods. Set the top plate behind the DAP with the cable still attached. Note: the guide rods and collars will remain in the DAP tower, tilted as shown. 5.
. Ensure that the cables did not get twisted when the top plate was removed. The cable should follow the arrows as shown. SHROUD INSTALLATION:. 1. Use the provided plastic push-in rivets to Install the Outside shroud and inside shrouds. There are four rivets per shroud as shown below. Before operation of this unit go through the entire machine and ensure that all bolts and fasteners are tight. Also verify that all moving components operate smoothly and freely.
HARDWARE GUIDE WARNING! Before using this product, it is essential to read the ENTIRE operations manual and ALL installation Instructions. The Owner’s manual describes equipment setup and instructs members on how to use it correctly and safely. Health related injuries may result from incorrect or excessive use of exercise equipment.
STAR TRAC 14410 Myford Road Irvine, California 92606 Telephone: (800) 228-6635, (714) 669-1660 Fax: (714) 508-3303 www.startrac.com Part No. 620-8050, Rev A.
