STAR TRAC FITNESS™ E-SERIES INTEGRATED WIRELESS RECEIVER KIT OPERATION MANUAL 620-7862 C Page 1 of 7
REGULATORY INFORMATION FCC When used in conjunction with the appropriate Star Trac cardio equipment, The MYE W IRELESS RECEIVER HAS been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of FCC rules. Under the FCC guidelines, operation is subject to the following two guidelines: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
INTRODUCTION The MYE ST-C9 (900 MHz) / ST-C8 (800 MHz) Wireless Receiver allows users to listen to a variety of wall mounted TV’s connected to 900/800MHz Transmitters. CONTROL BUTTONS POWER BUTTON HIDDEN KEY under the MYE logo Turns Main Console ON/OFF UP/DOWN BUTTONS Wireless Receiver Mode: Scrolls though programmed TV numbers (preset transmitters) DISPLAY CHAN Icon illuminates – Channel Number illuminates 1, 2, 3 etc.
EQ BUTTON Allows the user to scroll between preset equalizer tones. Each time the button is pressed a new EQ name will light up (the previous will disappear). DISPLAY EQ Icon always illuminated Flat, Bass illuminated one at a time MUTE BUTTON When the button is pressed the first time the audio MUTES. Pressed a second time turns Mute OFF and audio comes back ON.
SET UP INSTRUCTIONS Transmitter PROGRAMMING MODES (900MHz Version) During installation the controller must be programmed to lock the TV transmitters. The product is backwards compatible with all other brands of transmitters so there will be a total of five different programming modes. In each mode the receiver will automatically scroll through the frequency bandwidth and “lock-in” the transmitters.
To Add or Delete a specific transmitter channel press the HIDDEN KEY under the MYE logo. Each time the button is pressed it will add or delete a transmitter channel. DISPLAY- the PRESET ICON “ON” or “OFF” signifies transmitter channel is added or deleted. 5: To exit program mode press “EQ” button. The display will blank briefly and the unit will default to first transmitter channel programmed.
TROUBLESHOOTING: RECEPTION RANGE To change the controller reception to Near/Far, make sure the controller off. Press and hold down the VOLUME UP button, then press and release the POWER button. Continue holding the VOLUME UP button for three seconds until ‘LO’ is displayed on the console. This configures the Controller for “Near” reception. If this procedure is repeated, the display will indicate ‘HI’ and the Controller will be configured for “Far” reception. The factory default setting is “Far”.