User's Manual

100171-03 Water Meter Interface

Final Assembly Procedures 8000171-60-01

March 11, 2003 Page 1

StatSignal

Systems, Inc.

* * C O N F I D E N T A L * *

1. SCOPE

This document provides the procedures required to safely and

efficiently install the 200171-xx Water Meter Circuit Board

Assembly with a 171404-xx battery assembly into the 171400-

xx enclosure to produce the 100171-xx finished good Water

Meter used by StatSIGNAL Systems, Inc.

2. REFERENCES

3. FCC STATEMENT

This equipment has been tested and found to comply with the

limits for a Class A digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This

equipment generates, uses, and can radiated radio frequency

energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a

residential area is likely to cause harmful interference in

which case the user will be required to correct the

interference at his own expense.

4. MATERIALS AND TOOLS REQUIRED

4.1 Materials

The following materials are required to enable

completion of the installation process:

a. 1 each Water Meter Circuit Board Assembly

(200171-xx)

b. 1 each Water Meter Lid (171501)

c. 1 each Water Meter Base (171502)

d. 1 each Battery Assembly (171500)

e. 1 each 3V BR-AG Lithium battery (362001)

f. 2 each 1” Double Stick Tape (777005)

g. 1 each 1.5-5.0 mm PG7 Cord Grip (222059)

h. 1 each O-RING Gasket (777000)

i. 4 each 4/40 x ¼ Pan Head Phillips Screws (777001)

j. 1 each 22 AWG 3.5” long red/black wire asby.