User's Manual

100171-03 Water Meter Interface
Final Assembly Procedures 8000171-60-01
March 11, 2003 Page 4
© Copyright 2003,
StatSignal
Systems, Inc.
All Rights Reserved
* * C O N F I D E N T A L * *
the Pulse input of the 200171 Circuit Board
Assembly.
3) Connect the battery leads to the 2/pin header at
reference point BATT of the 200171 Circuit Board
Assembly.
4) Check the O-RING Gasket (777000) for seal.
5) Push the 22/3 AWG wire assembly (222056) away from
the Circuit Board Assembly (200171) and over the
battery assembly (171404) and carefully place the
Lid Assembly (171501) on the Base Assembly
(171503).
*** NOTE***
Before proceeding to the next step, make sure the O-Ring
Gasket is properly installed to ensure the seal.
6) Using the Phillips Head Screwdriver and the 4
screws secure the Lid Assembly (171501) tightly to
the Base Assembly (171503).