User guide

C, E, I, or L

M or N

A, B, D, E, G, H, J, or K

Lifetime Limited Warranty

Strong™ Mounts have a Lifetime Limited Warranty. This warranty includes parts and labor repairs on all components

found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to prod-

ucts which have been abused, modied or disassembled. Products to be repaired under this warranty must be returned

to SnapAV or a designated service center with prior notication and an assigned return authorization number (RA).

For Technical Support call 1.866.838.5052

Lifetime

3. Insert the metal bushings into the top and bottom

of the lower pole (see illustration 3a) and attach

the back plate to the lower pole using the supplied

Hex Bolt, Washers and Nut (See illustration 3b)

with 17mm socket. NOTE: Backplate tilt adjusting

levers are oriented on the top.

5. Using help of another person, hook the

display with the mounting arms attached

onto the lower portion of the mount.

IMPORTANT: Using a Philips head

Screwdriver, tighten the security screws

on the bottom of the arms to make sure

the display is

not accidentally

knocked from

the mount.

6. To set the tilt, have one person hold the display

rmly while another loosens the tilt adjustment

levers (see illustration 6). Move the display to the

desired tilt angle and retighten the adjustment

ratchet levers. Cables may be routed through the

drop down pole of the mount.

Tilt Adjustment

Knobs

4. Attach the Mount Arms to your Display using

the bolts provided with your display or the

appropriate hardware from hardware kits 1-5.

Use a lock washer (C, F, I, or L) and M6 Washer (O)

if needed. Spacers (M,N) should only be used

for displays with curved backs or recessed

mounting holes.

Security Screws

090819

SM-CM-T-L

Universal Ceiling Mount

PAGE 1
3. Insert the metal bushings into the top and bottom of the lower pole (see illustration 3a) and attach the back plate to the lower pole using the supplied Hex Bolt, Washers and Nut (See illustration 3b) with 17mm socket. NOTE: Backplate tilt adjusting levers are oriented on the top. 3b SM-CM-T-L Universal Ceiling Mount 3a 4. Attach the Mount Arms to your Display using the bolts provided with your display or the appropriate hardware from hardware kits 1-5.
PAGE 2
WARNINGS HARDWARE KIT • These instructions must be read and understood prior to attempting installation. Professional installation or assistance is recommended. Pkg 1 (A) M4x12 Bolt (x4) (B) M4x30 Bolt (x4) (C) M4 Lock Washer (x4) • This mount is intended for use only with a maximum weight of 165 lbs (75 kg). Use with weights heavier than this may result in instability causing possible injury. • The mounting surface must be capable of supporting the combined weight of the mount and the display.