Manual

101
WPS-100-DVR-8CH Installation and Users Manual
© 2012 Wirepath Surveillance
•DURATION
Set the duration that the Alarm Out relay and the buzzer will remain triggered when the corresponding
partitionisfull.Setthetimefrom3secondsto60minutesor‘-‘indenitelyuntiltheAlarmResetbutton
on the remote control is pressed.
•ALARMOUT
DenewhichAlarmOutputwillbetriggeredwhenthecorrespondingpartitionisfull.
•BUZZER
By default, the internal buzzer is enabled to sound when the corresponding hard drive partition is full.
•LOG
By default, the DVR will log when the corresponding hard drive partition is full to the event Log
•E-MAIL
Sendane-mailmessagetoapredenedemailaddresswhenthecorrespondingharddrivepartitionisfull.
9.4 DUAL STREAMING
This DVR offers two simultaneous video (and audio) streams to allow the DVR to record at a higher resolution
while streaming the video to remote devices at a lower resolution. Dual Streaming can be set two ways.
TherstoptionistosetCompression(foundinthePre-Cameratab)toHigh.ThesecondoptionistosetVideo
Stream (found in the Network tab) to one of the four QCIF levels.
Recommendation:Set Compression to Normal and use the Video Stream in the Network tab to enable
Dual Streaming.
Internet Explorer allows the user to choose which stream is being viewed, Record or Extra. Use the Modify menu
of
DeviceCong to change the video stream being displayed in Internet Explorer. The setting should be based
on the bandwidth capability of the network.
To access this menu,
select DeviceCong
icon from Internet Explorer.
1. Select the DVR to control and click on Modify.